1. Feeder Cold glass   1. Feeder Adjust feeder temperature   2. Machine Setup and Operation Machine speed too low Improper timing setup for forming cycle Too much final blow pressure Ware too cold Excessive swabbing Blank and blow mold are too cold   2. Machine Setup and Operation Increase the machine speed Check timing setup for forming cycle Reduce final blow Reduce cooling wind Reduce swabbing and use a clean, dry swab Adjust cooling wind setup   3. Mold Equipment Incorrect mold design Blanks and baffles not correctly matched   3. Mold Equipment Check for correct mold design Check blank and baffle match when the equipment is hot   4. Conveyor Container on the conveyor too long   4. Conveyor Increase the conveyor speed - that is increase the spacing   5. Lehr Operation Poor lehr loading Incorrect lehr temperature-unstable Unsuitable lehr belt Excessive draughts or wind due to position of lehr and prevailing winds   5. Lehr Operation Improve lehr loading Adjust lehr temperature and/or speed Use a more suitable lehr belt Protect from draughts, wind, etc.